|
|
|

|
Surf
Fishing For Bull Redfish (Red Drum)
|
|

|
|
Surf Fishing For Bull Redfish
|
|
|
|
|
|
|
|
|
|
|
| |
|
by Jerry LaBella
|
|
|
|
When
bull redfish move in along the
seashore (seacoast), boatless anglers will be right
behind.
Learn how to fish &
catch bull redfish along the surf, beaches, and seashore.
Surf redfish fishing methods, tips, tactics, and techniques for success.
|
|
|
With the arrival of fall, a sort of wild hiatus occurs, and not just along
the Gulf of Mexico, either. Frenzied surf anglers also pepper the shores from as
far north along the East Coast from Delaware all the way down to Florida. It is
here that the sandy seashores become a pincushion for sand spikes and 8 ft. surf
rods, not to mention the miles of tire tread prints from various 4 X 4 vehicles.
The key target for most of these pursuers is bull redfish (bull red drum).
What makes this type of fishing appealing to many anglers is you don't have to
have a boat to tango with these brutes of the surf. With a minimal investment of
a rod and reel, ice chest, and some items discussed later, an angler can have
success otherwise limited to those with a boat.
Accessibility is the key with this type of fishing, and it comes in many forms.
You can fish off the beach, a bridge or jetties, or other structure if you have
the proper equipment. Obviously, without a boat one would at least have to have
a vehicle that would allow for the transporting of all the needed gear to the
location of choice.
Careful planning is important because this kind of angling is more often a
waiting game. Therefore, to make it more pleasurable you need to bring all
the needed amenities: lounge chairs, sun canopy, refreshments, radio, etc.
There's nothing real technical about this type of fishing, which basically
involves casting a beefy piece of bait into the surf and waiting for a hookup.
There's no need, either, for any fancy working of the bait to enhance a strike.
What will be important, nonetheless, is that you periodically check the bait to
make sure you haven’t lost it and to keep it freshly changed about every 30
minutes or so, depending on bait type and how hungry bait thieves become.
The saying that "the more, the better" is definitely a principle to
follow when considering how many rods to use, but don't put out more than can
comfortably be handled. Use no more than two rods per person and try to place
baits in as many directions as possible, leaving a comfortable distance between
each. Likewise, when fishing from a pier or bridge you would want to fish both
sides, giving consideration to other occupants. Then, after everything is setup, pay attention to where the strikes occur, and relocate the rest of the rods
and reels undergoing less action to that vicinity.
Once all the rods and reels have been cast out, the handles will have to be
placed in a supporting device called a sand spike, or rod holder, which is
driven and secured into the sand away from any lapping waves. This device may
also be used wherever there's a place with a railing or similar fixture (bridge
rail, pier post, etc.) so that it can be taped or tie strapped securely to an up
right.
A sand spike can be purchased at most sporting good stories, but you can
construct one very easily. All you need for a sand spike is a 4 foot length of 1
3/4 PVC from your local hardware store. With the use of a hacksaw, cut one end on a 30-45
degree angle and the other end square. Clean the rough edges by scraping them
with a razor knife. The angled end is driven into the sand; the other end is for the rod handle to go into.
To prevent loss of rod and reel you must make sure that the drag on spinning
reels are set loose enough with bail closed. On bait casting reels, set them in free spool ratchet position, before placing them in the sand spike. After
placement, test to see if they will remain secured in the spike by pulling out
the line in front of the rod tip, simulating a fish strike. Adjust drag tension
accordingly so that spike will not be pulled from the ground or fixture to which
you attached it.
The game of patience begins when all lines are out and you're laid back sipping
on a cold one, waiting to be pleasantly interrupted by the loud clamoring sound
of your reel’s drag. When that happens, set the hook immediately and get the
other lines out of the water.
On bait casting reels put the reel into lock mode (fighting position); on
spinning reels tighten the drag enough to set the hook and allow for the run.
Despite popular theory, it's not necessary to wait before setting the hook when
catching bull redfish or black drum. These fish can engulf a fist-sized bait in
one inhalation. If you wait a few seconds before setting the hook the fish may
become gut-hooked, making it less likely to survive if you decide to release it.
Fight the fish long enough so that it wears down, and don't be overly
concerned if there's a lot of wave action. Keep the line taut and use the waves
to your advantage by allowing the surf to bring the fish right on the beach.
Once landed, keep it clear of the lapping waves or it may be sucked back out to
sea.
Fighting a bull redfish from a structure is an all together different challenge.
Here drag tightening and rod manipulation can make a difference between landing
or losing the fish. If a fish is headed for structure, such as piling legs,
rocks, etc., and the present drag setting is unable to turn him, you may take a
risk on tightening the drag more to head him off.
However, if that's unsuccessful, you might try the "gambling tactic"
if you are wary of line breakage due to abrasion. Since fish fight and run at
the sensation of resistance, put the reel in free spool or break the bail open,
which ever is applicable, and hope it steers clear of the potential obstacle.
Allow the fish a few seconds and resume the fight with your rod tip pointing to
where you want it to head–hopefully
out of cover.
Fishing above the water from a pier or bridge presents a different challenge.
Such places can make it difficult to landing the fish unless you have a bridge gaff
handy. Remember, the longer the fish stays idle in the water, the more likely
it'll rest enough and rebound, possibly putting you back in the same situation
you just got out of.
Like the sand spike, the bridge gaff is also something you can make. This device
allows you to gaff the fish and hoist it up to where you're located. This piece
of equipment is nothing more than a very large treble hook fastened to a 1 ft.
long shock leader of 200 lb. mono with about 1 pound of egg sinkers directly
above the treble hook eyelet. A 30-40 ft. length of 3/8 rope is then tied to this
leader after making a closed loop with the use of barrel crimps.
Landing a fish with the bridge gaff is relatively simple, if you have an
assistant to direct the hook so that it gaffs the fish under the mouth area. Once the fish is gaffed, immediately place the reel setting in proper
position to relieve any line tension (i.e. break bail, etc.) just in case the
fish breaks free from the gaff it won't snap your rod in two due to the fall.
Tackle is critical when scuffling with these broad-shouldered surf-runners. It
is therefore important to use at least 25 pound test mono line, but braided line
in at least the 6/30 class will be a better choice, particularly where structure
is eminent.
A stiff surf rod of 8 or more feet in length, with a reel of no less than 200
yards capacity will be mandatory. This type of rod makes for longer casts and
added leverage for maneuvering these heavy-duty redfish away from critical
structure.
A simple, effective leader to use is a fish-finder rig. This rig
allows the fish to take line without feeling the resistance of the sinker. These
are especially useful when fishing the surf since the line will basically stay
where you cast it.
A fish-finder rig consists of a 2-3 ft. length of 40 pound mono leader with an 8/0 hook on one
end and a barrel swivel on the other. On the tag end of the fishing line slide a
large snap swivel (eyelet end) up the line and place a pyramid sinker (at least
4 oz.) to the clip side of the swivel. Then tie the tag end of the fishing line
to the leader at the barrel swivel. Depending on size of bait, current and
waves, the sinker weight might need to be increased or decreased. Pyramid sinkers
are the key here since they will dig into the sandy bottom and hold your line in
position.
When using this type of leader setup, some have been puzzled when casting heavy
baits with too light a sinkers. What takes place is a short cast with the bait
traveling way beyond the sinker location. If this happens, increase sinker
weight to equal or more than the bait's weight. This will allow the sinker and
snap swivel assembly to remain nearer the leader section during the cast,
preventing it from double backing and entangling itself.
Many baits work well when going after bull reds; but make no mistake about it,
fresh is best. Squid, mullet, pinfish, porgies, croaker all work well. But many
veteran anglers choose whole or cracked crab because it is least prone to be taken by
sharks, catfish, or picked clean by bait fish.
Nevertheless, no matter which one you choose, one thing is for sure - when the
surf's red, the bull's will be fed!
|
|
Boatless
Bull Redfish fishing Spots to Try Along Louisiana's Coast |
The most popular pier and bridge fishing along Louisiana's coast can be
found at Grand Isle, La. Entrance to Grand Isle can be made via its
bridge on La. Hwy. 1. To the south and paralleling this entrance bridge
is the Grand Isle Fishing Bridge. This fishing bridge, made of wooden planks
and pilings, use to be the original entrance bridge to Grand Isle. It
spans across Caminada Pass located only a few blocks from the Gulf and
is a famous bull red fishing spot open to the public at no charge.
The Grand Isle State Park fishing pier, located near the end of the island,
gives easy access to Gulf fishing for a nominal fee. For info about
fishing, lodging, and other local events, call: (985) 787-2997 or click:
Grand Isle Tourism
Surf fishing takes place all along the beaches of Grand Isle and *Elmer's
Island all the way to Fourchon, for those with or without boats. Access
to Belle Pass rock jetties (W. side at the Gulf can be made via LA Hwy.
1 south to Hwy. 3090 Fourchon Rd.) to its end.
Fourchon's public boat launch is also located via this road. Vehicles
are prohibited on the beaches of Grand Isle, but allowed on *Elmer's
Island to Fourchon.
*NOTE: As of this article, Elmer's
Island is closed--check with Grand Isle Tourism for
latest info on any changes that may affect you. For more information on
Elmer's Island, see website: The Campaign
to Save Elmer's Island.
|
|
|
If you enjoyed this article,
please express your comments on the Guest
Book page and/or make a
donation of any amount to support this site:
|
|
|
|
|
|
| |
|
Disclaimer
Notice: All
information contained on this site,
including fishing articles, is for the purpose
of entertainment and is subject to inaccuracies
due to constant changes in laws and other
things beyond our control. Therefore,
names of places, laws, fishing methods and
lures, land configuration, creel size and
limits, fishing restrictions, quotations,
people, open or closed seasons or areas, etc. may not
be up to date. It is your responsibility
as the reader to make yourself aware of
any possible changes that may affect
you.
|
|
|
|
|
This site is best viewed with Internet
Explorer 6.0, free upgrade:
click
Netscape viewers must have 7.0 version, free
upgrade:
click
Copyright © 1999 by jerrylabella.com. All rights reserved.
Revised: 27 Nov 2007 19:37:43 -0500 .
webmaster@jerrylabella.com
General site stats
|
|
|
|
|
|